new to efi live. Im doing wideband VE tune. read the tur. Im using the LM 1 wideband set up. going to attach log. please help.
new to efi live. Im doing wideband VE tune. read the tur. Im using the LM 1 wideband set up. going to attach log. please help.
I dont think the lm 1 is not loging the data to efi live. dont know if i have the wrong PIDS selected.
How have you got the lm1 hooked up to Efilive? Serial connection or analog (using the orange connectors)?
The Tremor at AIR
Have you programmed the analog out from the LM1 to match the PID?
Are you using V1 or V2?
I have had some strange things happen before with a PID stuck at 0.0,
a reboot of the software cures this.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
im using the serial cable form taq
do i have the correct PIDS selected to run the lm 1. the V2 reads the afr.but I cant see it in the data list. but not sure.
Then you need the serial PIDS:
CALC.BEN1
EXT.WO2AFR1
EXT.WO2LAM1
EXT.WO2ST1
And make sure the V2 is set for the Innovate WBO2.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
OK I tried all of the above.it still will not log the BEN. it counts on and when u view the average it reads0.00