Hey all, I manged to get my LC-1 to work BBL but I am not having any luck getting it to work with pass through. Is there something I am looking over or whats the deal? I have everything updated to the latest..
Please let me know ASAP. Thanks guys
Hey all, I manged to get my LC-1 to work BBL but I am not having any luck getting it to work with pass through. Is there something I am looking over or whats the deal? I have everything updated to the latest..
Please let me know ASAP. Thanks guys
Do you have all the PIDs selected for it?
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
Yes I believe so. Refresh my memory though .
Will the 2nd LED still flash on the V2 unit if all is working?
I would like confirmation on how to hook up my serial cables. My sLC1 cable from TAQuickness is hooked into the 'out' on the LC1. Do I put the terminator plug in the 'in' side or what does that go to?
Thanks for the help,
Sam
Terminator plug must be installed in the terminal marked IN.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
Well that worked! Thanks for the help Mr. Prick.
I think Im all set. Is there any other settings I need to program to the LC-1 to make sure its accurate?
No that's it, just make sure you have done a free air calibration.
You can sanity check it by going into CL or SOL, the wb AFR should show stoich.