Results 1 to 5 of 5

Thread: map sensor issue?

  1. #1
    Member SGFastMax's Avatar
    Join Date
    Apr 2009
    Posts
    90

    Default map sensor issue?

    im working on a 2000 silverado that i recently put a z06 cam in. it starts hard and idles very rich and rough. would this cam make it run like this? Specs are 204/218 .550/.550 with a 117.5 lsa. i ran the scan tool on it and i didnt get a map sensor reading. the needle never moved off zero. the map PID was selected in the PID's and there wasn't a line through the map gauge in the digital dashboard, so i figured the sensor was picked up by the program but it never got a reading. anyone know whats going on?

  2. #2
    Member
    Join Date
    Apr 2009
    Posts
    53

    Default

    did you do a shift f2 to get calibrations of supported pids ???

  3. #3
    Lifetime Member ChipsByAl's Avatar
    Join Date
    Feb 2006
    Posts
    617

    Default

    If the MAP sensor was at fault or had a wiring issue to cause zero volts, you would get a DTC immediately. The engine would possibly not even start.
    Al
    "Trash that carb and get Injected!"

  4. #4
    Member SGFastMax's Avatar
    Join Date
    Apr 2009
    Posts
    90

    Default

    we unpluged the sensor and it started and ran the same as it did with it pluged in.

  5. #5
    Lifetime Member mr.prick's Avatar
    Join Date
    Nov 2006
    Posts
    3,195

    Default

    You're going to need fuel adjustments after a cam,
    but this will be impossible without MAP data.
    Did you try logging after a reboot of the software?
    Re-validate the PIDs and post a log with SAE.MAP and GM.MAP.
    512k RoadRunner Firmware 12.14R
    FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
    LC-1 WBO2

    _________________________________________________

Similar Threads

  1. TP sensor
    By Slowrc in forum Gen III V8 Specific
    Replies: 3
    Last Post: January 29th, 2009, 05:24 AM
  2. DTC O2 sensor
    By hymey in forum General (Petrol, Gas, Ethanol)
    Replies: 5
    Last Post: February 16th, 2008, 10:18 PM
  3. Anyone know of a 1.5 bar MAP sensor?
    By mistermike in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: August 19th, 2007, 07:57 PM
  4. O2 Sensor help please...
    By Fixer in forum General
    Replies: 2
    Last Post: October 22nd, 2005, 01:51 AM
  5. 2 Bar Map Sensor?
    By caver in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: September 6th, 2005, 04:56 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •