Remote Start configuration

[Max Power]

Is there any chance of having access to the remote start settings? For example it would be nice to change the run times from 10 minutes to 30-40 minutes or more. It would also be nice to change or remove the maximum amount of run times up from 2. Living where it can get down to -40 makes this remote start less then adequate.

[Brian1]

Not part of the ECM or TCM interfaces. Part of the BCM interface I believe.

Brian

[GMPX]

I'm not sure where the setting are stored, I think at least on the gas ECM's there is some parameters controlled by the ECM. Hey, it's coming in to Summer, you should be right now

[Max Power]

Ya I know but winter isn't far away.

I'll tell you it would be good for licence sales if I could change the run time. Is it hard to figure out Ross?

[GMPX]

I'm a little confused as you have an LLY right? But this post is in the LBZ/LMM?
It might not be too hard to figure out where the control is done.

[Max Power]

Sorry I now have an 09 LMM.

[Max Power]

Just a friendly reminder. I know you have lots on your plate.

[PinkoDiesel]

Is there any chance of having access to the remote start settings? For example it would be nice to change the run times from 10 minutes to 30-40 minutes or more. It would also be nice to change or remove the maximum amount of run times up from 2. Living where it can get down to -40 makes this remote start less then adequate.

x2 on that! I would love to change mine to more like 30min. Even for the summer time.

[Max Power]

Bringing this one to the top as it's starting to get cold out

[maxxflip]

I asked GM about this they said it cant be changed although they also told me the tpms cant be either so idk would be nice though