Using V2 as a WB readout

[turbo_bu]

Just wondering if I can power up my V2 and use it as a WB readout. Reason i am asking is that I would like to do some tuning on my dad's 32' Chevrolet with a LC-1 WB. I figure I will have to get the ground and power for the WB, but if could also hook up the V2 to power, without connecting to a vehicle PCM, it could serve as a readout OK. Anyone tried this or know if it works?

[mr.prick]

You can log EXT.PIDs without connecting to a PCM
by selecting Flashscan/Autocal only.

You will need to get creative for power and ground,
make sure it's fused.

[turbo_bu]

You can log EXT.PIDs without connecting to a PCM
by selecting Flashscan/Autocal only.

You will need to get creative for power and ground,
make sure it's fused.

Yeah, I am working on rigging up a power and ground for the project. Don't suppose you know if the screen will show the current value as well as log it? It would be handy to have a way to monitor the data while we are tuning other than dragging along a laptop.

[mr.prick]

Data is displayed once recording starts,
make sure you add SER/EXT PIDs to view those.
Then I guess put the V2 in a cup holder or hang it from the rear view mirror.