Question on Tuning with AutoVE tutorial
I've went the the whole process now and must admit my AFR is now getting close to commanded and my idle problems seem to have gone away.
My question is about using the MAP Averages to tweak the VE table. The manual says to repeat as necessary till the averages are right around 1 everywhere. I made another 30 minute log while runing my modified Original Tune per the manual, Original_Tune_0000.tun and am thinking I need to adjust my VE table with the logged BEN Map to keep tweeking it till just right. I have questions about this process. If you look at my BEN Map below for the 4000 rpm range, all the average values are 1.0. So when multiplying, nothing should change. That is not the case. If I copy with labels, then paste > paste and multiply with labels, the 4000 rpm range does change as do many other cells that have no values in them. I've also shown the before I paste VE table then the after I paste VE table from the multiplied values of the BEN Map. What am I doing wrong here? The changes should be very subtle as most of my average values are already 1.0.
Also notice the 4 cells for MAP 15 and RPM 2800 to 4000. Those cells are so high that they take the VE table cells thru the roof.
Reply With Quote