The scanner keep disconnecting in the middle of logs, I am on the dyno and the flashscan box in sitting stil and nothing has been disconnected. It will log for about a 1000 frames and just loose connection. Any ideas all of my hardware is brand new.
The scanner keep disconnecting in the middle of logs, I am on the dyno and the flashscan box in sitting stil and nothing has been disconnected. It will log for about a 1000 frames and just loose connection. Any ideas all of my hardware is brand new.
Can you post some screenshots from your PC... and also post the text from the Log tab.
Also, what vehicle is this happening on?
I no longer monitor the forum, please either post your question or create a support ticket.
V1 or V2?
My V1 drops connection to my laptop if I use a USB cable without ferrite beads.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
2000 C5 Coupe, 6M, Callies/Mahle stroked LS7 (441), Blackwing, Halltech, LS3 intake, 90mm Shaner TB, ported L92 heads, FAST 50# inj, not too much cam, Kooks 1 7/8" headers , 3" catless mid pipes, Z TIs, track suspension, , 3:90 rear, EFI V2, LM-2, etc.
PowrMax Performance
100 mm PowrMAF
LM-2 EFILIve package with TAQ -sLM2 V-2 serial cable> Package deals
Actually my V2 does the same, well when on the dyno with DVT enabled and scanning at the same time. I have to stop and start the scan tool again. Pretty annoying. No errors scanning just hangs.
Get EFILive in europe (http://www.efilive.eu).
2007 Escalade ESV L92 6.2L VVT.
2014 VF SV LS3 Maloo.
Most on 2010 camaros,and its a v2. I will get the screen shots. It just locks up, if I stop and start it will work again. I get no errors either.