Another missing PID

[gmh308]

I noticed another missing PID yesterday (or half a PID).

STFT1 & STFT2 are selected in BBL and shows in the V2 display.

Only STFT1 makes it into the log and also the export sheet.

Any chance this might be fixed in the next cut along with a few other missing items?

Thanks & have a good weekend!

Cheers, Ian

[swingtan]

What controller are you logging?

I just had a look at a log I did this morning and both STFT1 and STFT2 are there. They are listed in the PID selection, can be selected in the chart tool and display once selected. I can also select them for exporting.

However, as I was in OL the whole time, the trim data is coming up as "0". So if the problem is that the data is always "0", then it would appear to be a conversion issue with the raw data.

Simon.

[gmh308]

What controller are you logging?

I just had a look at a log I did this morning and both STFT1 and STFT2 are there. They are listed in the PID selection, can be selected in the chart tool and display once selected. I can also select them for exporting.

However, as I was in OL the whole time, the trim data is coming up as "0". So if the problem is that the data is always "0", then it would appear to be a conversion issue with the raw data.

Simon.

E38 .

I will have to cry "Operator Failure" on this one, at least as far as the Scan log goes, and apologise to all!

Though on re-try for export, only one STFT column is output, with both STFT selected.

[gmh308]

E38 .

I will have to cry "Operator Failure" on this one, at least as far as the Scan log goes, and apologise to all!

Though on re-try for export, only one STFT column is output, with both STFT selected.

Is there a limit to the number of export columns Paul ?

Have a good weekend!

[Blacky]

Is there a limit to the number of export columns Paul ?

Have a good weekend!

No.

[gmh308]

No.

Ok, so I should be getting valid SHRTFT1/2 data in the export file, vs a single column with N/A as the content?

The SHRTFT1/2 PID's are the "sub PID's" of selecting O2S11/2 in BBL via Scan and Tune.

Display OK in scan app, but dont export.

Have a good weekend.

[GMPX]

It was a parameter that was not used in those early OS's, sorry. Just compare the injector flow tables between 2006 & 2007 and you can see what is going on.