Hey guys, I posted this over on Diesel Place but either noone knows or noone cares to reply... so i figured I would try here.
Hey guys, I have been having issues with a DSP5 tune that I have been trying to run.
Before I put in a DSP in I would modify the Fuel vs Speed table (B0747) and it would work fine. Now since the dsp it seems on any tune either than stock it doesnt read this table. For example when I log the truck and watch it, it will command 70MM3 and when I open the tune program and look up the table the cell that it should be reading is highlighted and is calling for 52MM3. Why is this?
I've tried full flashes, partial flashes, but still it does not change. I am at a loss and was woundering if anyone would know why its not calling the B0747 table when it is in any of the DSP positions.
Any tips would be helpful...
Thanks guys