Results 1 to 2 of 2

Thread: M.A.F. Problems

  1. August 26th, 2009 #1
    rennoc442
    rennoc442 is offline
    Junior Member
    Join Date
    Jul 2009
    Posts
    20

    Default M.A.F. Problems

    So my ses light comes on and off, scanned it, code is 101 for the maf sensor. I have .75 Lbs at idle, is this within range?
    Reply With Quote Reply With Quote
  2. August 26th, 2009 #2
    eficalibrator
    eficalibrator is offline
    Senior Member
    Join Date
    Apr 2009
    Posts
    178

    Default

    0.75 lb/min is a reasonable idle airflow. Check to see if the signal is intermittent or view the raw Hz to see if that's consistent first.
    ~Greg
    Calibrated Success - EFI Training and Tuning Done Right
    GM Beginner's Guide DVD available now through Summit!
    Engine Management: Advanced Tuning - Amazon's best deal for the EFI crowd.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Help problems......
    By VACARELLAB in forum Duramax LB7
    Replies: 7
    Last Post: April 14th, 2009, 12:16 AM
  2. V2 problems
    By GAMEOVER in forum FlashScan V2
    Replies: 4
    Last Post: January 17th, 2009, 01:05 PM
  3. 2 problems
    By 1fastgto in forum Gen IV V8 Specific
    Replies: 3
    Last Post: December 26th, 2008, 05:27 AM
  4. Serious problems again - please help
    By Boost in forum Gen III V8 Specific
    Replies: 14
    Last Post: September 10th, 2007, 12:12 PM
  5. lc1 problems
    By woody69 in forum General (Petrol, Gas, Ethanol)
    Replies: 14
    Last Post: May 3rd, 2007, 07:39 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules