I was attempting to update the firmware in my V2 & during the process the screen went blank with two alternating orange lights and is stuck there. Any ideas?
I was attempting to update the firmware in my V2 & during the process the screen went blank with two alternating orange lights and is stuck there. Any ideas?
i had similar problem where the firmware didnt match the boot loader or something to that effect and it would stay in "dead poll mode." (flashing orange lights) i contacted IRA on this forum and he just had me send it to him in LA and he fixed it and sent it back havent had a problem since.
Carefully read attached (you may be able to recover).
If you still can't recover, then contact Ira.
Ok, now it shows a Boot Block of 2.05.08 & a Firmware of 2.05.14. The screen is still blank & when I try to update any further it says that it isn't connected. If I put it is Dead-Poll mode & try to update the firmware there it will program but it can't reboot the V2 & I get the error. Am I missing something here?
After messing with it for a bit, I think it is updated & functioning properly. I think I updated in the wrong order between the boot block & firmware. Thanks to everyone that replied.
Glad you got it figured out...
2008 2WD Ext.Cab Silverado 1500 6.0 V-MAX E38(L76) & T42(4L70E) MAF Only CL Corvette Servo AFE CAI INNOVATIVE LM-2 WBO2
FLASHSCAN V2 & AUTOCAL