Noticed dyno PIDs in the scan tool, what dyno's are currently supported? Is it a serial input to V2?
Noticed dyno PIDs in the scan tool, what dyno's are currently supported? Is it a serial input to V2?
It's all good until it goes "Bang"
We are currently working closely with an Australian dyno manufacturer and once we have some test results we will publish more about that.
The interface to FlashScan is publicly available and all dyno manufacturers are invited to make use of the interface. The interface is described here:
/Program Files/EFILive/V8/Docuemnts/EFILive FlashScan Serial Protocol.pdf
(You mut have instaleld the latest pre-release software to have that doc installed).
Regards
Paul
Before asking for help, please read this.
Should have some nice logs and screen shots to show off early next week. It's going to be very impressive
I no longer monitor the forum, please either post your question or create a support ticket.
Yes , it should be good. But I have a feeling i'm going to be dissapointed to find out it's mainline.
It's all good until it goes "Bang"
Once other manufacturers see it they all want to join in I am sure.
We've already talked to DD and sent them documentation.
I no longer monitor the forum, please either post your question or create a support ticket.
I hope so, it's alot of $ to change camps.
It's all good until it goes "Bang"
I believe they already do it for Motec's etc, so it's not like it's not possible.
I no longer monitor the forum, please either post your question or create a support ticket.
Dynojet doesn't.... believe me.
"All that is needed for the triumph of evil is that good men do nothing..."