V2 asking for license again

[GAMEOVER]

I was working with a pcm, which was already licensed about a month ago and while I was in the process of loading a Custom OS but my V2 asked for another License????(weird) for the same PCM. After it was in "Dead Poll"(per instructions in tutorial) I was going to try & flash the original calibrations and it didn't happen...

[joecar]

I notified Tech Support.

[GAMEOVER]

Thanks Joe, I pm'ed Ross & Paul...

[joecar]

Cool......what PCM is this on...?

[GAMEOVER]

2002 (os-12212156) pcm-0411

[ScarabEpic22]

Try unchecking the use high speed mode box when you flash, I have a few P10s that arent cooperative unless that box is unchecked. Get the same error as you, pulls a serial number that is wrong. Reset everything, uncheck the box and make sure the serial numbers on your PCM are the same in the licenses box (About->V2 Vin Licenses) as what appears in the flash window.

[GAMEOVER]

Thats what I don't understand...If it's off the serial number, and we don't have access to the serial#, what could've happened? It all started after I put it into "dead poll". Trying to install Custom OS
I'll try what you suggest though...
Where does the serial number show up? In the tune? Or?

[ScarabEpic22]

We dont have write access, but we do have read! Shows up in the PCM info window or when reading/flashing. No access otherwise.

Check these screenshots out I posted a few weeks back in the P10 forum. I wrote in the images what was happening, Ill link them here.

http://forum.efilive.com/attachment....9&d=1253089867

http://forum.efilive.com/attachment....0&d=1253089867

http://forum.efilive.com/attachment....1&d=1253089867

http://forum.efilive.com/attachment....2&d=1253089880


Notice how the serial number in my V2 window shows something ending in KGEB, then look at the first pic after that. The PCM info window is reporting the PCM has a different serial, ends in 00KG. Third photo shows the issue with the high speed box checked and the same 00KG serial number and the license PCM. Fourth photo shows high speed unchecked, KGEB serial number, and proper flashing. Yes this is the exact same PCM, check the time stamps out, no way I can move everything from car to car in a matter of seconds.

Sorry, cant link to them without them being HUGE.

[GAMEOVER]

I see what your talking about. I did try unchecking high speed but no go....
I full flashed this PCM and then did a couple of calibration only flashes...This morning I tried loading in a Custom OS and I've been stuck ever since...
I can't figure out what happened!

[mr.prick]

Are you using the new firmware by any chance?