im trying to get my aem ugeo to work with my v1 but im not having much luck. anyone have any ideas? i just downloaded the 7.5 build 88 version. thanks.
im trying to get my aem ugeo to work with my v1 but im not having much luck. anyone have any ideas? i just downloaded the 7.5 build 88 version. thanks.
Which AEM?
There are a few with different outputs, one is non linear.
This calc.pids.txt for dual sensors and the non linear dual sensor (30-2300 & 30-23001)
calc_pids(AEM).txt
Disclaimer: the non linear PID has not been tested.
Last edited by mr.prick; November 29th, 2009 at 05:48 PM.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
im not sure if its linear or not im borrowing it from a friend. this isn the one i have though http://forum.aempower.com/forum/inde...c,21559.0.html last link at the bottom model 30-4100
ok i tried using the calc that you posted but it was way off what the gauge was showing. i then went to aems site and copied all the lookup voltages compared to the afr it seems closer but not quite there...
It fixed it.
Analog Output Voltage Mode: P0
Last edited by mr.prick; October 16th, 2009 at 06:33 PM.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
I read in another thread that you could get away with using the PLX PID's for the AEM 6 in 1 part number 30-4100 wideband as they use a similar linear formula. For simplicity I used the plx pid's for my aem and it appears to be working well. Is this an exact match or is there anything wrong with me using the plx pid's for the long term?
The PLX and the linear AEM are the same.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
much thanks prick