Results 1 to 2 of 2

Thread: programming LC-1

  1. #1
    New Member
    Join Date
    Oct 2009
    Posts
    1

    Default programming LC-1

    Hey everyone, first time poster here. Just trying to get started with this tuning stuff.

    I finally got my LC-1 all wired up and installed. But I'm running into some difficulty when trying to program it. I hooked the serial cable to my laptop and tried plugging it into both in IN and OUT lines of the LC-1 but it keep getting a no HW found error message. What am I missing here??? The instructions state to hook the Terminator plug to the serial IN but I have no clue as to what the Terminator Plug is. I only have one serial cable that came with the unit. What else do I need to hook up in order to program and use the sensor? Thankf for any help.

  2. #2
    Lifetime Member mr.prick's Avatar
    Join Date
    Nov 2006
    Posts
    3,195
    512k RoadRunner Firmware 12.14R
    FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
    LC-1 WBO2

    _________________________________________________

Similar Threads

  1. Programming the DIC
    By Whippled 496 in forum Tips and tricks
    Replies: 8
    Last Post: December 14th, 2012, 03:44 PM
  2. Need Help Re-Programming The BCM
    By cwksf in forum General
    Replies: 0
    Last Post: July 26th, 2009, 02:05 PM
  3. T42 Programming Problems
    By arubenstein in forum 4speed RWD/FWD Transmission Tuning (incl T42)
    Replies: 16
    Last Post: March 22nd, 2008, 05:55 PM
  4. Issues with LS7 programming
    By Jason S. in forum Gen IV V8 Specific
    Replies: 17
    Last Post: March 11th, 2008, 10:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •