Since the last update my precious V2 looses connection to
the PCM while logging for unknown reasons.
This is unpredictable and quite annoying.
Am I the only one going through this?
Since the last update my precious V2 looses connection to
the PCM while logging for unknown reasons.
This is unpredictable and quite annoying.
Am I the only one going through this?
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
No, there have been some other reports of this also. We still don't know what is causing it.
If you are able to reproduce it consistently, please document the conditions so we can try and reproduce it here.
Regards
Paul
Before asking for help, please read this.
I thought I could reproduce it, but I can't.
I happens sometimes and sometimes it does not.
All I know is that it start immediately after the new FW.
If I power off the V2 then reconnect it will be fine.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
Any news on this?
Can I go back to the previous FW without consequences?
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
I've had this happen before on my earlier version,but I put it down to the small lap top going to sleep. It was a very long log though about an hour an a half.
2005 HSV Maloo Ute, HKE 457ci Stroker LS2 E40, TFS 245's, 255/263 Hi Lift HUC, FAST LSXr 102, NW Billet 102 TB, FLT Level 7 4L65E, CircleD 4200 stall, Duspeed OTRCAI - Mafless, DF 1 7/8" LT's, 3" DiFilipo Duals, Serial LC-1 WB's
"An Old Dog learning new tricks"
I have been trying to get a scan on a 97 lumina 3.1 I had given to me.
but it will not allow me to see the standard pids. for example when i try to access the vss it is listed as not currently valid.
Also when I try to get DTCs it stalls the car. this battery is so bad it will not start the car again without a boost.
I'm posting to this thread as I'm pretty sure the cause is the bad battery which I need to replace. may or maynot be the cause of some disconnects some have had.
Any thoughts
Alex
Alex,
Did you validate pids after connecting to the 97 Lumina...?
Bump for a FW fix.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________