Anyone using serial output from FJO WB?

[67SS509]

Been trying to get my EFIlive to work with the serial output from the FJO (GEN2). Can't get past "Controller Not Found" when programming the V2.

Talked with a FJO tech person today. He said it will not work with EFIlive. Now I don't know who to believe. If anyone has FJO-serial working please let me know.

[joecar]

Try this: swap the Tx and Rx wires in the FJO cable.

[67SS509]

Try this: swap the Tx and Rx wires in the FJO cable.

I tried that today. Same result. I did get the pin location from the FJO tech for the Tx and Rx. My hook up was correct to start with.

[joecar]

I pm'd Tech Support.

[67SS509]

Thanks. I really want to get a serial wideband working. If the FJO is not going to do the job for me which model no. of the Innovate do I need?

[joecar]

Which FlashScan V2 firmware do you have...?

[67SS509]

Which FlashScan V2 firmware do you have...?

Where do I find this?

[Blacky]

Which FJO unit do you have?
FJO won't publish the serial protocol specs for the later FJO models.

Still, we have "reverse engineered" the protocol for the late model units but I can't gaurantee that they will work.

Also make sure you have the latest FlashScan firmware, V2.06.16

Regards
Paul

[joecar]

Use EFILive Explorer to see what firmware your V2 has...

[67SS509]

Which FJO unit do you have?
FJO won't publish the serial protocol specs for the later FJO models.

Still, we have "reverse engineered" the protocol for the late model units but I can't gaurantee that they will work.

Also make sure you have the latest FlashScan firmware, V2.06.16

Regards
Paul

It's a GenerationII FJO with the NTK sensor. It will be tomorrow before I can get the V2 firmware number.

Thanks