QUICK!!! Tried Auto VE tuning and now I have a problem

[12sec.5.3]

Done everything step by step as the tutorial's instructions say and after updating the calibration differences from alternate to primary tune my VE table is completely blank. No numbers or anything just white cells. Cranked it up and it will not stay running bc it is so lean. Sounds like a top fuel car though... hehee. Please help. Only thing I could think of that was wrong was something when building and applying the filter bc the tutorial did not give a thorough explanation on it.

[GAMEOVER]

Post up your tune file...

[mr.prick]

You copy primary VE to the back up VE.
If you can, upgrade the OS to something w/o a back up VE table.

[12sec.5.3]

I might have done something wrong so I redone it. My VE table looks to be wayyy off with crazy high spikes in it so take a look.

[12sec.5.3]

Also, After I load my new tune do I replug my maf? I tried and it still doesn't want to run. Maybe the maf has to be calibrated now too?

[mr.prick]

Dude that VE table is fktup.

[12sec.5.3]

lol. yes i know. If i send you my log could you help figure this out?

[mr.prick]

There is something wrong with the data that was applied to the VE table
or/and the way it was applied.
Post the log that resulted in the tune posted above and
what data and how it was applied.
FYI
you have LTFTs/Closed Loop enabled,
therefore the AutoVE process is moot.

[12sec.5.3]

This is the log

[mr.prick]

Your WBO2 is not configured right, EXT.AD voltage is low.
This is giving you incorrect AFR/BEN data.
Check the fuel settings and voltage output in Logworks.
A free air calibration would be a good idea too just to make sure that is not the cause.