OK if i enable B2201, and set B5401 to my desired RPM will this work on my 2001 corvette z06? Id rather use these tables than B3303, to set my RPM limiter...

B2201 and B5401 uses ETC to enable rev limit.... ( want to use )

B3303 uses fuel cut-off to enable rev limit.... ( dont want to use )

I have a nitrous car (dry shot useing cos5) and i perfer not to use fuel cutoff to limit my revs just incase the tranny (4l60e) slips at the track during a WOT run...

so is it possible? anyone done it before?

thanks...