need help with lanos 2001

[weref]

hey,


i'm new at this so after some reading i connect my leptop to the car's aldl.
when i 'm trying to to start reading data, with any xml, it gives me this error:

13:47.863: Opening COM1 8228,8,N,1
13:48.818: Start macro: Clear diagnostic trouble codes: CLRDTC
13:48.828: Send: $F5,$57,$0A,$00,$AA
13:48.950: Com timeout: Expecting frame header byte
13:48.958: Stop macro: Clear diagnostic trouble codes: CLRDTC

check run:
21:01.961: Check vehicle interface...
21:01.966: Waiting for Aldl bus silence of at least 50ms...
21:02.016: Requesting Max232 interface to acknowlege: $FF,$55,$AC...
21:02.027: Max232 interface detected OK

21:02.030: Scanning for heartbeat and chatter frames...
21:02.030: Waiting for Aldl bus silence of at least 50ms...
21:02.187: Com timeout: Expecting frame header byte
21:02.198: No chatter found


can anyone walk me step by step?

[Blacky]

It looks like your interface cable does not echo the Max232 commands back to the PC. In that case go into the properties and uncheck the "Max232 Echo" check box.

Regards
Paul

[1FastBrick]

FWIW some Daewoo's have trouble comunicating with scan tools. We have the actual Scan-100 DAEWOO scan tool at the shop I work for. Some cars will not conect to that and we have to try and hook up a small hand held scan tool to see if we can read codes and live data. You might also try another scan tool and see if it will conect to that. Also check the fuses... I cant remeber wich fuse it is but sometimes That will also cause an issue. So far I have seen 2 Daewoo's that would not conect with any scan tool. It could also be a loose pin at the ECU. Unfortunitly most customers won't spend any money to Diagnose the problem.

Good luck!

[weref]

thanks i gonna try again this weekend.
which .xlm should i use for my lanos 1.5 2001?