Pid question

[boccheballs]

I was wondering if anyone could let me know how all my pid's became invalid?
I had a selection of 13 pid's i had data logged with several times successfully. Now when i go in the pid folder and click to open it it says pids not valid error code $31 and says the pcm is not sending the info. So i go to the info and try to validate pids and keep getting the error code. I cannot seem to get any of them to work. If i go in on my pc everything works fine, oh and my edge insight monitor is getting all the pid's just fine. It has to be something simple any help would be appreciated.
Brian

[boccheballs]

Well i stewed on this at work for 12 hours i came home and typed up the above question. Of course now that have typed it up it took about 30 minutes to figure out that somehow it lost my vin and specific info. I filled it in and back to working. Thanks

[joecar]

Hmmm, I wonder how it forgot the vin.

[duramaximizer]

Mine won't log 15 pids it would before also. I didn't lose my VIN, but it did change my engine to the 5.7 gasser rather than the Duramax and I also lost my weight that I had entered for the performance aspect.

[joecar]

I keep losing my vehicle weight too.

[boccheballs]

Mine is doing it again too. Keeps going to 5.7l and 0.000 on the weight.

[Blacky]

You really need to configure a "customer" for your vehicle's VIN. The customer details are used to populate the same details in each log files as you record it. When you load in a previously recorded log file (and a matching customer is not found) the customer details are changed to the details in the log file. If there are no details in the log file then EFILive defaults those details to, well defaults.

Regards
Paul

[duramaximizer]

My
ENGTRQREF_M [2] Engine Torque Reference (Nm)

PID still isn't working is there an update I haven't done yet. V8.1.2 Build 81? Boot Block 2.06.02 Firmware Version 2.06.21

[boccheballs]

http://download.efilive.com/Software....104_Setup.exe
http://download.efilive.com/Software...2.84_Setup.exe

these are the newest ones i think

[bballer182]

My
ENGTRQREF_M [2] Engine Torque Reference (Nm)

PID still isn't working is there an update I haven't done yet. V8.1.2 Build 81? Boot Block 2.06.02 Firmware Version 2.06.21

yeah that build is a month old or so.

http://download.efilive.com/Software....104_Setup.exe
http://download.efilive.com/Software...2.84_Setup.exe

these are the newest ones i think

yeah i'd try this one.