Hey guys, I am wondering if there is a way to control a boost control solenoid like an AEM/MAC valve or GM solenoid. Is this even possible? If so I am assuming I would have to go to a custom operating system...
Thanks,
Steve
Hey guys, I am wondering if there is a way to control a boost control solenoid like an AEM/MAC valve or GM solenoid. Is this even possible? If so I am assuming I would have to go to a custom operating system...
Thanks,
Steve
Last edited by spoolinsteve; May 19th, 2010 at 04:11 PM.
Hi Steve,
No, not possible... the FlashScan device does not have outputs.
A COS will give you boost fuel/timing tables that are used with a 2-bar/3-bar MAP sensor, but no external control.
If the BC solenoid is a GM device then you would have to run the ECM that goes with it, and I am not familiar with this.
Thanks Joecar! I been searching the forums alot and you are always on top of your game it seems when it comes to helping!