This is what I see
I downloaded the USB drivers and unzipped them. Where are the placed?
Feel free to delete this post. Geezer attack
Thanks for the responses
Elmer
So is it working now? Should I ask what the problem was? Was it just a case of installing the USB drivers?Originally Posted by eboggs_jkvl
Paul
Before asking for help, please read this.
woo hoo
"If you can leave a black mark on the pavement, from the exit of one corner to the braking point of the next one, you have enough horsepower."
Originally Posted by black02ss
Ouch! Quit talking about my "vice". Actually, just a sheer case of stupidity. I grabbed the wrong cable out of the bag. I actually use the A-Tap serial cable and wasn't paying attention and grabbed the ls1edit cable.
On another note:
I want to record Injector Duty Cycle 1 & 2 and it's showing as invalid PID. I have recordings where I recorded that data but now it says I can't record it.
Injector Pulse width bank 1 & 2 are also showing invalid.
Now, I rebuilt the engine, (Same PCM) and basically I have an LS6 engine with 60 lb injectors.
Why have thos 4 PIDs gone away? I did a shift-f2 to "refresh them but they still show as invalid. I'd really like to use those on this car.
Elmer
Hmm... Do you have the latest build E? There was a small lapse with Pre-Release 011 and it was updated again just shortly after.
Originally Posted by black02ss
Hey! I've been sick! You had releases coming out the wazoo and I haven't a CLUE where I'm at on this software! :p
I'll check, just a sec...
V7.3.0 (Build 303)
obdiiV7.dll 7.3.0 (Build 446)
is on the laptop.
Yea need a update. Give that awhirl and see how it turns out for ya.