Anyone know what wire the tacho outputs on an E67 and does it need a pull up?
cheers
Anyone know what wire the tacho outputs on an E67 and does it need a pull up?
cheers
C1 pin 25 White
---------------------------
E38's got to love them
E40's hate 'em
LS1's is there anything it wont work on
Holden VE SSV - GEN46L
www.ultimateconversionwiring.com.au
www.dualflash.com.au
Now working, needed an 900 ohm pull up as signal pulls to ground. This is an E67 GM motorsport package, I have been warned about the OS being different and not upgradeable. I can't get EQ_VE to run on it either. I'm also having issues with high timing on decel, I have reduced the High and Low Oct maps, the idle maps, the overrun maps and I am still getting a hanging idle with 40 degrees timing above 3000 rpm. Makes for the gear changes to be ordinary as this is a manual.
Last edited by 4wheelin; March 3rd, 2010 at 05:24 PM. Reason: Got it working
Sorry to hear that...
its as the old saying goes.. get what you payed for...
they may be cheaper than the local suppliers but they dont always work out right
have heard lots of bad things about these GM performance packages - Specially for us Aussies as alot of it is designed for left hand drive.. then there are the E67 and OS problems...
is it not best to start with a fresh TIS base of an E67 and then go from there instead of mucking round with that OS?
---------------------------
E38's got to love them
E40's hate 'em
LS1's is there anything it wont work on
Holden VE SSV - GEN46L
www.ultimateconversionwiring.com.au
www.dualflash.com.au
Couldn't get the timing down but fixed the hang with reduced idle final air flow.
I have got this stock thing going well but it would be a lot of effort if it had a cam.
---------------------------
E38's got to love them
E40's hate 'em
LS1's is there anything it wont work on
Holden VE SSV - GEN46L
www.ultimateconversionwiring.com.au
www.dualflash.com.au