Quote Originally Posted by GMPX View Post
If I recall it was the 2009+ OS's that would shut off the injectors if the starter relay was not connected, when we added the cal to change the starter relay type it fixed that issue.
I could see a more positive look in your eyes at the end of your mini Virtual VE table training session at PRI, mission accomplished, that alone justified your airfares
I'm just going through my first VATS delete using a E38 ecu stand alone and I have ignition but no injection while cranking.
Is it the G1220 setting on the factory "apply to 12 V" that causes this?
We're using a independent starting system.
Setting it to "Not used" will hopefully sort it.
I'm trying to sort this remotely you see so its a bit painful

thanks,
Mike in NZ