Results 1 to 3 of 3

Thread: Erro after connection

  1. #1
    New Member
    Join Date
    Nov 2005

    Default Erro after connection

    I downloaded Version 5 eval version to use with my T16 interface. I get connected just fine and can validate PIDs and pull DTC's, however when I go to log data I get an error message in the console view that appears constantly until I end the monitoring....I don't have the logs from the weekend but I think the message was error 32. unused error or something like that.

    Any help would be appreciated.

  2. #2
    EFILive Developer Site Admin Blacky's Avatar
    Join Date
    Mar 2003


    Can you copy the the text fromthe console display and paste it into an email and send it to

    Before asking for help, please read this.

  3. #3
    New Member
    Join Date
    Nov 2005


    Found the problem...the scan mode needs to be OBD II Generic. By default it is set to GM Slow Dynamic.

    I would like to purchase a license for Version 5 to use with my multiplex t16 interface, mostly to collect Generic OBD Data. How would I go about getting a license and what's the cost. I didn't see version 5 listed at your store.

Similar Threads

  1. Not connection to E67 ECM
    By khalidmmukhtar in forum E37, E38 & E67 PFI ECM's
    Replies: 3
    Last Post: March 9th, 2010, 08:40 AM
  2. LC-1 serial connection
    By nathans1987 in forum Tutorials
    Replies: 11
    Last Post: May 26th, 2009, 11:08 AM
  3. No connection!
    By jamesbond2509 in forum General (Petrol, Gas, Ethanol)
    Replies: 14
    Last Post: May 7th, 2008, 12:33 PM
  4. Problems with V2 Connection
    By SV8346 in forum FlashScan V2
    Replies: 26
    Last Post: February 26th, 2008, 12:44 PM
  5. No connection
    By jannes_z-28 in forum General (Petrol, Gas, Ethanol)
    Replies: 6
    Last Post: August 1st, 2007, 08:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts