First off, I'd like to thank Shawn and the supporting cast for putting together a nice tutorial. I've been reading and following along while trying to set up this method of tuning on a 2004 Z06.
Well, today is the day. The car is warmed up and on the dyno. I connect everything and my WBO2 BEN Multiplier isn't working. It doesn't like my
CALC.AFR.Dyno PID.
I'm using the WBO2 from the dyno. Supposedly it's made by Autronic. There has been a 0 to 5V drop spliced into it for datalogging purposes. I made a rookie attempt at creating a Calc PID for it. I would prefer to run a serial cable from the WBO2 to the V2 but I don't know if it's supported.
Can anyone point me in the right direction? Go easy on me!
-Brad