If it's V2 hook up the power, ground and LED circuits and then use the serial connection, lot more accurate then using AD inputs and no fuss to calibrate.
Thanks. Feel like I should start my own thread, but I thought putting it here might be appropriate. I have FlashScan V2. I'm not one to do thing half-a**ed!
My LC-1's serial out adapter terminates with a female 9-pin serial connector So I'm guessing I need an adapter to connect the female serial -> RS232 cable included in EFIL?
Glad I checked the forums. If I'd followed the instructions within the program, or even the Innovate instructions, I'd have spent a lot of time and effort to be screwed. LOL!
See post #3 of this thread: showthread.php?9340-serial-port-cable-that-goes-to-v2
Forum member TAQuickness sells pre-made LC-1 V2 serial cables, see his signature: showthread.php?7867-gt-gt-gt-General-Tuning-Information-lt-lt-lt
Oh, it's like that.....
Thanks for the link. Got one of the cables en route. I'm not one for unnecessary adapters on something so signal-sensitive.
Last edited by Filmjay; May 28th, 2010 at 06:12 PM.
Some people like to make their own cable, others like to use the cables that came with (requires the $2.45 null-modem-adapter), while others like a unitized ready made cable...
I did all 3.
I'm intending it to be a semi-permanent install, so the full unbroken cable is the only option for me.
Thanks again. I'm sure I'll be back w/ a plethora of more questions.