help finding efilive explorer

[restless@westnet.com.au]

i have lost efilive explorer from my windows start up ??
i have reloaded efilive 5.7 latest ver but it is still not there ??
im not very good with a pc and have just got a v2
to start logging my e38 any help would be appreciated
thanks

[Tordne]

EFILive Explorer is part of the version 8 software; so you need to have version 8.1.2 Build 94 installed.

Then EFILive Explorer can be found in your Start menu (Programs\EFILive\V8\EFILive Explorer).

[restless@westnet.com.au]

EFILive Explorer is part of the version 8 software; so you need to have version 8.1.2 Build 94 installed.

Then EFILive Explorer can be found in your Start menu (Programs\EFILive\V8\EFILive Explorer).

ok got it thanks

[restless@westnet.com.au]

thanks
now i cant seam to get the v2 to work anymore
when im in efilive control panel f6 FIRMWARE
with the v2 connected it says boot block OK in green v2 bootblock ver 2.06.03
and the firmware ver is OK ver2.06.34
but when i try to use it it says options.txt not found it was working OK with the old ver
so how do i activate it with the new ver boot block and firmware
thanks

[joecar]

Hi Restless, welcome to the forum...

Connect V2 to PS, start Scan&Tune (S&T) program, goto F5:Black Box Settings,
and press the Program button (see the Program button at the bottom of attached pic).

Doing that will get Options.txt copied to your V2.

[restless@westnet.com.au]

thanks for that
it started to load at 84% and then said
ERROR$:0194 WRITE FAILURE ??

[joecar]

thanks for that
it started to load at 84% and then said
ERROR$:0194 WRITE FAILURE ??

Did you Format the Config space...?

Exit S&T, then...

Start EFILive Exlporer (EE), goto F9:Config Files, press Format Config.

When the format is finished, exit EE and go back into S&T, goto F5:Black Box Settings and try the Program button again.

[joecar]

I made Tech Support aware of this.

So you got build 94, and have flashed 2.6.34 into your V2...?

[Tordne]

I think as Joe suggests you will be best to format the config and data filesystems. This is especially true if the firmware you have now updated from was quite old.

[restless@westnet.com.au]

NO
i didn't con-fig the space
i have done that now and it it is loading the pid list of e38/t42
how many pids can i load will it take 100% program
or is it best to have as few as possible
i have been having trouble with BBL logging going bad after about 10min after starting to log with the old version trying to log on to the lap top is hopeless as the graph takes about 5min to go across the screen it was OK when Steve ostrack first set it up but went bad soon after
any ideas on what could be the problem i can shoot you a page shot if you like of what it looks like
thanks for your help so far its very much appreciated i can tell you