order question

[wesam]

Thanks Tordne i appreciate your help

[Tordne]

Just sent you an email back. Happy to help . Strange you didn't get the tracking number automatically.

[wesam]

i received your mail thanks a lot for help
it seems that the shipment is ready for collect

[wesam]

i received the flash scan today
every thing went fine but i don't know how i could attach the AEM wide band to the flash scan
there is a female serial cable came with the flash scan but there is no male cable with the wide band there is just a blue cable for serial data
when i read the user manual they said i should connect the blue cable to pin number 2 in the male serial cable which i should purchased and the pin number 5 should be grounded
does they mean i should connect those two cables to the serial cable which came with the flash scan or should be connected to computer serial port ?
and after i connect the cables is there any configuration in the scan tool
i have read the EFILive V75 Scan tutorial but still don't know what to do
any help will be appreciated

[Ira]

You need to get a matching connector to the EFILive serial cable and then connect the black wire to pin 5 of the EFILive connector and the blue wire to pin 2 or 3. Before permanently connecting it to pin 2, I'd make sure it works as the pin number changes between 2 and 3 depending on the sex of the connector.

Ira

[wesam]

OK i got it
but this is in the hardware side
what about the software side
i tried to find i PID for AEM serial wide band with out luck
what should i do
I'm i missing some thing ?

[mr.prick]

PIDs for serial WBO2:

[Parameters]
CALC.BEN1=1,4221
EXT.WO2AFR1=1,4375
EXT.WO2EQR1=1,4436
EXT.WO2LAM1=1,4377
EXT.WO2ST1=1,4379 

[wesam]

forgive me for this stupid question but where should i put those parameters ?

[joecar]

EXT.WO2AFR1
EXT.WO2EQR1
EXT.WO2LAM1
EXT.WO2ST1

In S&T you can set to log those pids automatically, see the first pic.

Then set which wideband you have, see the second pic.

(remember to Save to file and to Program to V2).

After logging, you copy the log file from V2 to PC, and open with scantool, those pids will be there.

[wesam]

joecar i did what you told me then i opened the Flash scan 7.5 and add a PID EXT.WO2AFR1 then start the scanning but it did not read any thing
the wiring is OK and i put a voltmeter and i could read a 2.4 Volt and when compare it to the table in the AEM manual it gave me the same A/F as in the gauge
i think i missed some thing
please moderator help me I'm trying since three days to read from wide band