I decided to finally set up my program to the Corvette and record some data. I installed a new CAI on the LS2 and I wanted to see the fuel trims. I understand that I might toss a code with the CAI and I thought I'd look to see if there was some "ugly" hiding in the wings.
I keep getting error messages during the recording. Something about out of range. I do see my Short and Long fuel trims at -100 (that's a bit off) My IAT went from 108F to -40f (I live in Florida, not gonna happen), Speed dropped to 0 MPH in a blink.
So, what the hell did I do wrong this time. I must have something set up wrong.
I attached my 2 log files where I had the error. I also attached my error files.
V7.5.6 Build 117
Old guy messed up again,
Elmer