IMPORTANT
• {B4205} Closed Loop Temp Enable: Set to max setting
Engine->Fuel->O2->Parameters.
• {B4108} STFT Idle Enable: Disable
In EFILive’s 2 and 3-bar Operating Systems, power enrichment (PE) mode can be
prevented all the way up to full boost. If you are using the {B3647} Open Loop
AFR calibration as shown above,
then there is no need for PE mode below
100kPa. Above 100kPa, the PCM will continue to command the value in the
rightmost column of the {B3647} Open Loop AFR calibration. You could then have
PE mode activate at say, 150kPa to command a richer AFR.
Page 15 has further explanations on how to set up for boosted applications.
In this table the PCM will average the values between cells, this means in this
table the commanded AFR between 95kPa and 100kPa will be somewhere
between 13.8:1 AFR and 12.5:1 AFR (AFR values shown, NOT EQ Ratio).
support@efilive.com www.efilive.com