Is there a write up or a tutorial on how to tune your MAF after dialing in onrs VE table? If not anyone mind pointing me in the correct direction?
Thanks
..RJ..
Is there a write up or a tutorial on how to tune your MAF after dialing in onrs VE table? If not anyone mind pointing me in the correct direction?
Thanks
..RJ..
Do this:
Follow the AutoVE Tutorial with these exceptions:
- enable MAF (undo the MAF fail steps),
- set B0120 to zero,
- setup BEN map to look exactly like B5001 (using copy-with-label and paste-labels),
- log MAF and MAFFREQ.
It works the same way... obtain a log, apply transient filter, paste/multiply BEN map into B5001.
I sometimes log DYNAIR while in OLSD after having finished AutoVE, and I use its values as an initial MAF table.