Okay, I installed my LC-1 per the instructions at http://www.innovatemotorsports.com/r...1_tutorial.pdf :

Red wire going to a free Acc port in the fuse box
Yellow goes to pin C on a Flashscan v1
Blue, Green, and White go to pin D
Black goes to the LED and pushbutton (in parallel) and then through them to ground.
Brown is not connected.

Wideband is on a separate bung, it will not be emulating an NB sensor.

It doesn't work. The LED is constant, pressing the button to start calibration does not do anything other than turn off the LED. Trying to connect via LM Programmer gives a "please connect the device to a serial port" error message. My laptop is old enough to have a real serial port so I am not going through an adapter.

I saw a thread that looked similar at http://forum.efilive.com/showthread....-lc-1-help-plz. but frankly it confused me. Are the instructions as given from Innovate incomplete -- should there be a connection between D and ground, or should brown/blue/white be connected somewhere other than D.. or is there a power switch somewhere on the LC-1 that I'm not seeing or something along those lines?