B0188 for LS1/6?

[Highlander]

I noticed there is an IAT calibration table for the E38s/E67s.

Is there such a table for the LS1s?

I am using an LPE 100 MAF sensor and it's reading 13F higher than normal.

At start up in the morning, both ECT and IAT should be the same or extremely close.

THere is a huge difference between both and I wish to calibrate for this. ALthough I am mainly using MAF based fueling, it's kind of annoying seeing the reading and accounting for the difference.

[GMPX]

From memory the scaler was hard coded in the OS for the sensors on the LS1.

[Highlander]

Thanks... guess i'll have to keep tuning around them...