Missing calc.pids

[curtbriggs]

Paul,
1, the PID list from the AutoVE tutorial.
2. It just describes what the PID is, not what the problem is.

Thanks, Curt

Maybe the unsupported PID you are looking at is not a calculated PID? Which PID is it (are they) exactly?

OK DESCRIPTION CAPTION UNITS SYSTEM CH PARAMETER
- Absolute Throttle Position TP % - Throttle 1
OK DESCRIPTION CAPTION UNITS SYSTEM CH PARAMETER
- Commanded Air Fuel Ratio AFR :1 - Fuel 2
OK DESCRIPTION CAPTION UNITS SYSTEM CH PARAMETER
- Engine Coolant Temperature ECT °C,°F Imperial Temperature 1
OK DESCRIPTION CAPTION UNITS SYSTEM CH PARAMETER
- Engine RPM RPM RPM - Conditions 2
OK DESCRIPTION CAPTION UNITS SYSTEM CH PARAMETER
- Ignition Timing Advance for #1 Cylinder SPARKADV Degrees - Spark 1
OK DESCRIPTION CAPTION UNITS SYSTEM CH PARAMETER
- Intake Air Temperature IAT °C,°F Imperial Temperature 1
OK DESCRIPTION CAPTION UNITS SYSTEM CH PARAMETER
- Intake Manifold Absolute Pressure MAP kPa,inHg Imperial Air 1
OK DESCRIPTION CAPTION UNITS SYSTEM CH PARAMETER
- Retard Due to Knock KR Degrees - Spark 1
OK DESCRIPTION CAPTION UNITS SYSTEM CH PARAMETER
- Vehicle Speed Sensor VSS KMH,MPH Imperial Conditions 1
Paul, the above are all selected but have the red X.
The only two that are Calculated are OK, the two PLX PIDs. The analog voltage and the cyl/grams are also OK.
I didn't have this problem with the pre-release 7.3, why now?
I'll go over all your replys in this section and see if it makes sense.
Thanks. Curt

[Blacky]

Have you changed the VIN in your PCM?

Can you please generate an error report (Ctrl+G) and send it to me at paul@efilive.com. Thanks.

Paul