Lost all wideband analog and serial pids

[Wichita Dyno]

After latest update ive lost all wideband and calc. pids I use for auto ve tuning. Can someone help me through this? Thanks in advance.

Chris

[joecar]

Hi Chris,

Use the Scan&Tune (S&T) software (comes with V8 install), see attached... click Program to program it to your V2.

[Wichita Dyno]

Thanks so much for the help. Awsome software and support!

[Wichita Dyno]

I did as shown above and also updated firmware and boot block. Still when I connect to vehicle all wideband, analog and serial as well as ben's dont show up as supported pids for this 00 transam. Im guessing its a problem with calc pids? V2 is set to proper lc1 serial wideband. Any help would be appreciated.

[Tordne]

Are you Black Box Logging or pass-thru (using the Scan Tool)?

[Wichita Dyno]

Im using the scan tool with laptop on dyno to tune and data log.

[mr.prick]

It's okay if they are not valid.
Select them anyways, once you start logging they will become valid and data will be visible.

This happens sometimes with passthru.

[Wichita Dyno]

Even if I select wideband pid i cant seem to find my ben pids.

[Tordne]

There were a couple of Serial PIDs actually shown in the WBO2-Analogue section incorrectly that was corrected in the last update. So, perhaps they have just moved?

[mr.prick]

Were these PIDs made by you or EFILive?
Is it possible the calc_pids.txt was written over after a new install/update?