So is it safe to say that the V2 wont comm. with anything but ECM,TCM on a E38 ECM on CAN network?
So is it safe to say that the V2 wont comm. with anything but ECM,TCM on a E38 ECM on CAN network?
here is the VIN 1G1YY26E865132583 But i already have a RPO list from the Stealership that does not list F55 or UE1
Plus i get the same result when i hook up to the boss's 2009 Chevy silverado with the E38 on CAN
PM me the VIN of the Silverado also.
Last edited by joecar; September 23rd, 2010 at 08:27 AM.
Silverado VIN is 1GCEK29059Z173665
If the 2006 Corvette doesn't have F55 then the suspension controller is not present... but the BCM and ABS controllers should be able to communicate.
I couldn't get a list of RPO's for the 2009 Silverado.
ok when i try to validate all on board OBDII modules it searches for engine and transmission controllers only. Here is a screen shot of the scan tool when i try to validate modules. i get the same message on the 06 vette and the 09 silverado. Everything is configured as described in previous posts, all software is up to date V7.5.6 build 133 V8.1.2 build 115 Bootblock V2.06.03 Firmware is V2.06.41
Last edited by Ralf"s Rides; September 27th, 2010 at 08:05 AM.
That is correct, in V7.5 software only engine and trans controllers are supported when using CAN mode.
To see/scan trouble codes from other modules, use the on-board FlashScan F3: Diagnostics menu.
When the V8 scan tool is released it will fully support all modules.
Regards
Paul
Before asking for help, please read this.