What are the procedures for validating pids for BlackBox logging? Here is what I tried.
After loading the pids from my PC. I go to:
Flashscan\Program selected pids into Flashscan
click on Validate
click on Setup
a Warning "This option will erase erasing previously recorded log files in the Flashscan" I select "yes" to continue
Then, this comes up "Flashsan is now ready for validating pids on target PCM"
I select "OK"
I then remove Flashscan from the PC
Go to my car and plug Flashscan into the ALDL connector
Turn the key to "ON"
Flashscan cycles all the lights once, then the yellow and green lights flash continuosly.
I then press the Start/Stop data Logging button on the Flashscan.
But, nothing happens.....no other LED's light up other than the yellow and green lights blinking. The blinking does not stop.... even after several minutes.
Is there somethig else I should be doing?
Everything else works fine, ie; scanning, logging , reading from PCM, loading a tune to the PCM.
Thanks,
Andy