flash scan for gauges

[Tordne]

Because you're coming from such old firmware do the following:
- Connect FlashScan V2 to your machine
- Open the EFILive Explorer application
- Go to the 'F3: Data Files' tab and click the 'Format Data' button; make sure there is nothing on there you want/need beforehand obviously.
- Go to the 'F9: Config Files' tab and click the 'Format Config' button
- Close EFILive Explorer

- Open the V8 Scan and Tune application
- Configure the device options and Save/Program them to your device
- Configure the BBX options and Save/Program them to your device


With regards to the screen being blank... Is is a few rows of pixels that are out or something? We don't sell FlashScan V2 interfaces by themselves really. The couple of options are to send it into us for repair. If it is outside of warranty (which I assume it is given the firmware age) there may be a cost for repair. Or, we offer a service to close a FlashScan device. This costs US$499 and provides you with a brand new interface with a new 12 month warranty.

Let me know if you'd like to send for repair and I'll provide the details to you via email.

Cheers,

[crash85]

now i can go ad put it in the truck and use it as gauges or do ineed to do something else?
what all do i need to send you for the repair just the flash scan?

[Tordne]

I'm assuming you're in the USA right?

You should be good to o now, hopefully.

[crash85]

yea its working and iam in the usa

[crash85]

thanks for yalls help

[Tordne]

It will have been due to the changes in filesystem structure at some point way back. Formatting was going to be the most likely fix. If that hadn't worked it was more likely to be a flash memory fault, which would have been bad