Results 1 to 2 of 2

Thread: Correct pids for VVE tuning

  1. #1
    Lifetime Member 68problemchild's Avatar
    Join Date
    Mar 2010
    Posts
    315

    Default Correct pids for VVE tuning

    What are the pids for Ben Factor for WB innovative?

    I think I found WB 02 AFR.

    What PID do you read to make sure your tune has failed the MAF and you don't need to pull the yellow wire?

    Thanks so much.
    Last edited by 68problemchild; December 12th, 2010 at 12:45 PM.

  2. #2
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    For E38 using wideband serial comms : CALC.WO2AFR1, E38.AFRATIO.DMA, CALC.BEN1_E38.

    The MAF is failed if the ECM sees any of these DTC codes: P0101, P0102, P0103.

    Also see here: showthread.php?8961-E38-VVE-Setup-Guide

Similar Threads

  1. Tuning MAF vs VVE
    By minytrker in forum E37, E38 & E67 PFI ECM's
    Replies: 14
    Last Post: August 27th, 2009, 12:29 PM
  2. VVE question
    By Ed@Late Model Speed in forum E37, E38 & E67 PFI ECM's
    Replies: 1
    Last Post: February 19th, 2009, 09:28 AM
  3. Tuning on the dyno, PIDs to log...
    By BlackGMC in forum Gen III V8 Specific
    Replies: 8
    Last Post: April 16th, 2008, 06:00 AM
  4. which pids for ve tuning w o2s
    By ssmike300 in forum General (Petrol, Gas, Ethanol)
    Replies: 5
    Last Post: February 1st, 2008, 10:52 PM
  5. Idle Tuning with new pids (calc pid file included
    By Dirk Diggler in forum General (Petrol, Gas, Ethanol)
    Replies: 57
    Last Post: October 4th, 2005, 01:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •