Calc.VET: correcting MAF and calculating VE (in single log)

[COONDOG96]

OK I added the calc_pids.txt file looked ok but when loading the pids (CalvulatedVE,Not corrected) did not come up valleid was still X out. When I did a log {B0101} map after averaging came up all 0s. {B5001} had what looked like good # to me ????. I went back and looked at the calc_pids.txt file and CLC-00-320 is not in there could that be it??? Also I then tried to find the 320 text and now I have bouth the scan and tune are locked up I get an erior massage witch I sent in. So now I'm dead in the net. Will try to send the log but not going to lost is post again

logError code: ERR_WIN 0/0

Cannot open file "C:\Users\Owner\Documents\EFILive\V7.5\User Configuration\calc_pids.txt". The system cannot find the file specified

[COONDOG96]

Log_0005CAL.VE.efi

logError code: ERR_WIN 0/0

Cannot open file "C:\Users\Owner\Documents\EFILive\V7.5\User Configuration\calc_pids.txt". The system cannot find the file specified

log

[COONDOG96]

Log_0005CAL.VE.efi

[COONDOG96]

I hope the log got there I can't open it anymore no scan or tune

[joecar]

logError code: ERR_WIN 0/0

Cannot open file "C:\Users\Owner\Documents\EFILive\V7.5\User Configuration\calc_pids.txt". The system cannot find the file specified

Start scantool, go Edit->Properties->Folders, highlight User Configuration, click Browse and browse to the correct folder, click Ok, click Ok...

exit scantool and restart it.

[joecar]

I can see the log file...

[COONDOG96]

Can't as soon as I x out the err. report it closes the sacn tool

Start scantool, go Edit->Properties->Folders, highlight User Configuration, click Browse and browse to the correct folder, click Ok, click Ok...

exit scantool and restart it.

[joecar]

Hmmm... DAT is high at 154F.

[COONDOG96]

I know that it an air temp but it comes from what?

Hmmm... DAT is high at 154F.

[COONDOG96]

It is a blown motor so iat is in the upper plentom