Page 5 of 5 FirstFirst ... 345
Results 41 to 42 of 42

Thread: Loosing 4th once converter is locked

  1. #41
    Lifetime Member
    Join Date
    Aug 2010
    Posts
    1,934

    Default

    Perhaps ... but perhaps not ... depends if the trans temp sensor in use is compatible with your original TCM tune ... would have been helpful to have retained the original trans temp sensor for diagnostic purposes. This is generally not an issue, but given your situation the more variables you can eliminate, the better.


    Regards,
    Taz

  2. #42
    Senior Member alian's Avatar
    Join Date
    Jun 2008
    Posts
    140

    Default

    Joe state 9 and 10 dosnt work with my set up, I have tried to validate them without success.
    Taz, There is not alot of T42/E38 combos in Aus. Unfortunatly My box went back to the builder(over 2000kms away ) and would have been built and be in someone elses car by now. So it could be something quirky but I am still looking. I suppose I could get onto Holden and see if theTrans temp sensor for my vehicle has the same part No as the rest of the T42 boxes. Worth a look. ( at least that would eliminate that) The TFT sensor is reading about right as it sits pretty close to the ECT all the time.
    Cheers Ian
    Last edited by alian; May 6th, 2011 at 10:32 AM.

Page 5 of 5 FirstFirst ... 345

Similar Threads

  1. 06 Vette locked in 4th
    By Xman in forum 6 speed/8 speed RWD/FWD Transmission Tuning (incl T43, T76, T87)
    Replies: 20
    Last Post: December 9th, 2008, 07:12 PM
  2. Wide Band Loosing Calibration
    By sdhager in forum General (Petrol, Gas, Ethanol)
    Replies: 5
    Last Post: September 23rd, 2008, 12:30 AM
  3. How to keep converter locked at 0% throttle
    By thunder550 in forum 4speed RWD/FWD Transmission Tuning (incl T42)
    Replies: 13
    Last Post: April 23rd, 2008, 09:52 AM
  4. Keep TCC locked in 4th gear
    By FnGone in forum 4speed RWD/FWD Transmission Tuning (incl T42)
    Replies: 10
    Last Post: February 24th, 2008, 11:02 AM
  5. Loosing 18* of timing at WOT!
    By johnsZ06 in forum Gen III V8 Specific
    Replies: 4
    Last Post: June 2nd, 2007, 08:39 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •