PID for LMM not working

[LBZoom]

Hey guys,
the torque reference PID is not working on the LMM's that I'm logging, I downloaded the PID selection to the BB and when I play it back it's showing N/A... any insights?

Also, on the LB7 PID's, the base torque PID isn't reading correctly either even though I'm okay on my number of channels, it continually reads 800-998lb ft.... any other reports of this?

Thanks guys!

[Tordne]

In all cases can you please indicate/define the absolute PID that you are referencing?

Also, please confirm that the issue is believed to be with V2 BBL? Does it function correctly in V7 pass-thru?

[LBZoom]

PID issue is with both V8 BBL and V7.5 pass through logging....

LB7 PID in question is GM.DMAX_TRQ_DMA

LMM PID in question is GM.ENGTRQREF_DMA

[Tordne]

Have you found it to be off on just a couple of trucks, or a few? Could you also provide the operating system numbers you're using on these trucks?

[LBZoom]

So far 2 LB7's OS#'s 86006, and 89044 I believe.

The LMM PID, I've only logged one OS# lately but I suspect it's occurring across the board, the OS# I logged was 28594