C.A.S.E learn issue using flashscan V2 and EFI V7.5.6 SW

[Leonard Sparks]

Gentlemen,
Having a issue to getting the CASE relearn procedure to activate. Started engine, monitor through dashboard until the minimum temperature was reached, P/N switch activated, foot off brake. Click on DVT link, Click the activate button as described in the procedures for the V7 SW. Should come up with another screen, showing rpm, tps position, etc? The window does not pop up as described in the instructions. No alarm telling me start the procedure as well.
I am using the V2 scanner with the lastest update ( passive pass through) along with the EFI live7.5.6
This is on a engine/pcm swap in my Camaro.
No codes are present that would keep the procedure from running, except for the P1336.
Am I missing a piece of the puzzle here?
Thank you for your help in advance.

Leonard

[joecar]

LS,

When you click on the C.A.S.E. button, you then have to open the throttle and bring RPM up over 4000 rpm... you have 10 seconds to do this in... when engine misses for a moment, immediately release throttle and allow RPM to spin down to idle, then turn off key and wait 15 seconds.

[joecar]

See here:

CASE Relearn:
http://forum.efilive.com/showthread....-crank-relearn