Logging wideband afr with autometer

[68sstt]

Can anyone point me in the right direction, i have an autometer wideband in my car and wish to log with bbx.

I have setup what I think is the correct calc.pid for my analogue output but after reading some posts i am not sure. I will more than likely not be using this for autove but just for logging when doing some hard runs or 1/4 times. attached is the file, is this correct? and if i need to write another calc.pid do I add to this file or create another file.
The gauge has a 0-4v output with 0v=10.0 afr and 4v=16.0afr

calc_pids.txt

I can see the pid in the scan tool but cannot find the pid in bbx software, what do i do to add the pid to the logging software and upload it to flashscan

Thanks

[joecar]

Hi 68sstt,

The calc pid does not show up during BBL...

When you open the BBL log in the V7 scantool, you can go the the PIDs tab and add that calc pid...

after adding the calc pid, if you then save the log file, the calc pid will now be part of the log.

[68sstt]

Joecar

Thanks for that I have not done much logging yet still new to the system, Will try logging my car tonight and checking that out!

[joecar]

68,

Look at the V7 button in the pics in post #6 here: New-V2-help-find-exlporer

if you click on the V7 button, you can specify calc pids which will be loaded when you open the V7 scantool to view a BBL log.

[68sstt]

68,

Look at the V7 button in the pics in post #6 here: New-V2-help-find-exlporer

if you click on the V7 button, you can specify calc pids which will be loaded when you open the V7 scantool to view a BBL log.

Thanks joecar

Got the logging sorted out now and I believe my afr is accurate enough for all intents will now check against autronic on dyno this weekend.