tried a new card still the same mesg ?
it does load the pids and logs fine
the only time you dont get the mesg is if i use the FAST OPT on the drop down box on the program button
tried a new card still the same mesg ?
it does load the pids and logs fine
the only time you dont get the mesg is if i use the FAST OPT on the drop down box on the program button
Blacky said to format the Config space (which resides on V2's internal flash).
You just load in your options file with the BBX settings and controller selection and then click the 'Program' button.
Andrew
EFILive Crew
restless,
also be sure to update V7 and V8 software from here...
V8 includes V2 firmware that you flash into V2 using EFILive Explorer (installed with V8).
thanks for the help
i reformat ed the card in the v2 (instead of the PC) and it now works OK
i have up dated both V7 and V8 to the latest version and up graded the boot block and firm ware to 2.07.01 and 2.07.09
ONE question
WAY doese the v2 display WO2.AFR1 and lambarda and EQ dater wo2 afr2 ect
when i have AFR only in the setings selected and (PID wo2af1#1)
theres lots of read outs reagarding afr eq lambarda ect at the bottom of the list on the v2 screen
afr comanded and wo2afr1 is at the top of the list as per pid list just woundering way im geting all the other stuff is it inter conected
i have all ways had it since i put the tech2 wide band sensor in
thanks for help
With the serial wideband, the V2 reads all the WO2 pids in one go.
Connect FlashScan, run the V8 EFILive Scan and Tune software, select F6: Devices and then F6: Logging.
Click on the [Read] button to read the config settings from FlashScan, then check the value of the setting shown in the attached screen shot.
If necessary, change the setting and click [Program] to program the new settings back into FlashScan.
You don't need to "save" the settings unless you want to keep a backup copy of the changes on your PC.
Regards
Paul
Before asking for help, please read this.