Results 1 to 4 of 4

Thread: GMPP E67 LS2 Crate checksum issues

  1. #1

    Default GMPP E67 LS2 Crate checksum issues

    I read the stock file out and it had all checksums disabled. I ran the checksum fix and reflashed. The car runs fine but does not appear to be accepting any changes like idle speed etc... I read the file out again and noticed that the OS checksum still says it's disabled. The rest of the checksums are ok after the first calibration reflash.

    I'm assuming I need to do a full reflash with the updated checksum to fix this? I've never ran into this before and I just want to make sure I'm not going to brick this E67 with a full reflash. It still runs fine as of right now with a calibration only flash. I got no errors during the flash.
    Aaron L.
    Conover, NC

  2. #2
    Lifetime Member GMPX's Avatar
    Join Date
    Apr 2003
    Posts
    13,148

    Default

    Yes, you need to full flash the ECM to apply the OS checksum fix.
    It's probably not necessary for you to do that at this stage though. The checksums must be fixed prior to flashing because EFILive's reflash process will not allow the ECM to reboot to normal running mode unless the checksums are 100% correct. As you have already applied the checksum fix to the calibrations area that is fine for continuing to do cal only flashes.
    I no longer monitor the forum, please either post your question or create a support ticket.

  3. #3
    EFILive Crew Site Admin Tordne's Avatar
    Join Date
    Oct 2004
    Posts
    3,870

    Default

    He'd logged a helpdesk ticket also, and I said basically the same thing
    Andrew
    EFILive Crew


  4. #4

    Default

    Thanks guys, that is what I was thinking but I wanted some input before I did the full reflash.
    Aaron L.
    Conover, NC

Similar Threads

  1. GMPP E67 Issues
    By 540sscamaro in forum E37, E38 & E67 PFI ECM's
    Replies: 8
    Last Post: October 11th, 2010, 11:12 AM
  2. GMPP E67 and Cruise Control
    By 95wagon in forum E37, E38 & E67 PFI ECM's
    Replies: 10
    Last Post: September 29th, 2010, 03:39 PM
  3. E67 GMPP controller checksum error
    By xtreme in forum E37, E38 & E67 PFI ECM's
    Replies: 3
    Last Post: November 10th, 2009, 02:50 PM
  4. LS2 with GMPP E67 - advice needed
    By V8RX7 in forum E37, E38 & E67 PFI ECM's
    Replies: 4
    Last Post: July 2nd, 2009, 11:20 PM
  5. LS2 472bhp out of the crate (engine dyno)
    By Gelf VXR in forum Gen IV V8 Specific
    Replies: 1
    Last Post: June 3rd, 2008, 01:22 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •