PIDs for E38 & T43

[mr.prick]

Can I get a couple pid lists for these two controllers?

2009 Holden Commodore w/left-hand drive option.

[swingtan]

Depends on what you want to log.......

Here's what I currently log via BBL.

ECM,  IAT
ECM,  AAT
ECM,  SPARKADV
ECM,  MAP
ECM,  VSS
ECM,  ETCTP
ECM,  APP
ECM,  ECT,             ,                                         -10:110:9:10:0
ECM,  INVLVTMP_M
ECM,  KNKRET,          ,                                         0.0:1.0:131:10:0
ECM,  OCTSCL_M
ECM,  MAFFREQ2
ECM,  AIRPERSEC
ECM,  MAF
ECM,  APCYL_M
ECM,  RPM,             ,                                         0:6200:66:10:0
ECM,  AFRATIO_M
ECM,  INJPWB1
ECM,  INJPWB2
ECM,  SHRTFT1
ECM,  SHRTFT2
ECM,  HO2S11
ECM,  HO2S12
ECM,  BRKR
CLC,  BEN1_E38

Also the serial PIDs for the Techedge WB.

It's been a while since I seriously logged a T43 though. If we were talking T42, then I use the following...

TCM,  ACCEP
TCM,  RPM
TCM,  TBASEPAT
TCM,  VSS
TCM,  GEAR
TCM,  BRKR
TCM,  SHIFTLAST
TCM,  IAT
TCM,  ECT
TCM,  TFT
TCM,  TRQENG_C
-,    DYNTRQ
TCM,  TCCP
TCM,  TCCS
TCM,  SHIFT34
TCM,  SHIFT23
TCM,  SHIFT12
-,    DYNPWR
TCM,  ADAPTCELL
TCM,  ADAPTSHIFT
TCM,  TURBINE
TCM,  TFMDES
TCM,  TFMCUR
TCM,  TCSLIP
TCM,  TCCSLIP
TCM,  TFMDC

Simon

[mr.prick]

Thanks.

Nice car Simon, I always liked it.

[mr.prick]

Is there a trick to reading the PCM?

I am getting bootloader rejected error.

The previous owner may have locked it because there is a CAI installed and
looking around other forums I find CAI & some type of lousy handheld flasher is popular with these vehicles.

The TCM read with no problems.

[joecar]

Is there a trick to reading the PCM?

I am getting bootloader rejected error.

The previous owner may have locked it because there is a CAI installed and
looking around other forums I find CAI & some type of lousy handheld flasher is popular with these vehicles.

The TCM read with no problems.

What car did you get...?

[swingtan]

I take it you selected the E38 pid list prior to reading ?

[mr.prick]

I selected the E38 controller, if that's what you meant.
The supported vehicle list shows Pontiac G8 has E38.


I know some vehicles have issue reading/writing unless other devices are removed from the CAN bus.

What car did you get...?

2009 Pontiac G8

[mr.prick]

I need an E38 with stock OS & calz for this car while I have the PCM unlocked.
The closer to AZ the better.

Thanks

[swingtan]

I have a stock 2009 Holden SS-V tune.... but it's about as far from AZ as you are going to get. Will that work for you ?

Simon

Edit: I should note that this is for an AFM / DOD motor, so it's an auto.

[GMPX]

I know some vehicles have issue reading/writing unless other devices are removed from the CAN bus.

I know TIS says to remove fuses on some cars, but it's not necessary with EFILive on CAN vehicles.