Before asking for help, please read this.
June 24, 2011, here:
http://www.efilive.com/index.php?opt...=48&Itemid=133
However, I recommend updating the software using:
Start->All Programs->EFILive->V7.5->Tools->Check for New Update
and
Start->All Programs->EFILive->V8->Tools->Check for New Update
Regards
Paul
Before asking for help, please read this.
all works fine now
do you think the pid TRNR (manuel tranmision states) will work soon
cheers
Before asking for help, please read this.
you said a while ago it was not surported (unknown )
so i havent tryed it again
all so could you tell me were to put a trace file to read it
i have got it on the v2 and in explorer( bottom of the page )but witch part of efilive do you past it in to
to beable to read it
thanks
Last edited by restless@westnet.com.au; July 4th, 2011 at 06:17 PM.
See images, one is for V7.5 the other is for V8.
Regards
Paul
Before asking for help, please read this.
i have up dated every thing v8/v7.5/and the firmware /boot block to day
now i find that the E38 pid ( gear ) for the a6 just shows a 1 in neutral or unknown
all so says says unknown when its in gear ? on the v2 screen
BUT when you log it
it show which gear OK on play back on the PC screen in scan tool
all the other 34 pids show on the v2 screen OK
any ideas
cheers
Yes, I find the same thing... on V2 the encoded pids (e.g. TRNR, GEAR, TCCMDE, TSTATExx, STATExx) show value Unknown on V2 and show correct value in the V7 scantool.